Filename: SE165087.EXE
For: WinFrame Version 1.6
Replaces: WF160521, WF160523, SE165047, SE165050, SE165054,
          SE165078, SE165084
Language supported: English (US)

NOTE: You must install Service Pack 5 before applying this hotfix.


Description
-----------
This hotfix for Citrix WinFrame Version 1.6 addresses the
following issues:

1. This hotfix corrects the problem where some applications
   would not print graphics reliably to a NetWare print queue.
   [From Hotfix WF160521]

2. This corrects the problem where NetWare users could not login
   to their preferred server if the previous NetWare user did
   not have access to the server.  This was reproduced in an
   environment where the WinFrame server has access to all
   NetWare servers but user access is restricted based on a
   user's preferred server.
   [From Hotfix WF160523]

3. This resolves a trap during NDS logon and a memory leak
   during bindery logon.
   [From Hotfix SE165047]

4. This resolves a NetWare memory leak and an associated
   8001 Event Log entry.
   [From Hotfix SE165050]

5. Changing the NetWare password from WinFrame either
   succeeded where it should fail or failed all the time,
   depending on the minimum length setting on the NetWare
   server (<=8, always succeeds; >=9, always fails).  The
   new password length did not matter.
   [From Hotfix SE165054]

6. If an RSA function fails, the NetWare Redirector may zero
   invalid memory.
   [From Hotfix SE165078]

7. This hotfix corrects a problem where the Netware Redirector
   could send oversized frames to a NetWare server.  This could
   cause the NetWare server to abend.  For further information
   refer to Microsoft Knowledge Base article Q142675.
   [From Hotfix SE165084]

8. This hotfix corrects a problem seen in the Performance
   Monitor utility.  The Gateway Service for Netware
   connection counters reflected an incorrect number of
   NetWare connections.
   [From Hotfix SE165084]

9. This hotfix corrects a problem where applications that opened
   files on a NetWare server in DENY_READ and DENY_WRITE mode
   using DOS INT 21 function 3D would only open the file with
   DENY_WRITE set only.
   [From Hotfix SE165087]


Installation Instructions for Hotfix SE165087
---------------------------------------------
1. Copy SE165087.EXE to an empty directory on your hard disk and
   execute the command:

   SE165087

2. Execute the following command to install the Hotfix on your
   system:

   HOTFIX /I

3. Shut down and restart your computer.


Files Updated
-------------
hotfix   exe             56,608 09/10/97  03:21p 
nwrdr    sys            157,776 10/06/97  03:29p 
